User Manual

English
|
11
Rock "Rock"
Pops "Pops"
Easy "Easy"
Top 40 "Top40"
Jazz "Jazz"
• User memory: The values set on the 'Audio Control'
(page 11).
• Each setting value is changed with the 'Speaker
Setting' (page 11).
First, select the speaker type with the Speaker setting.
Audio Control
1 Select the source for adjustment
Press the [SRC] button.
2 Enter Audio Control mode
Press the [AUD] button for at least 1 second.
3 Select the Audio item for adjustment
Press the [FM] or [AM] button.
Each time the button is pressed the items that
can be adjusted switch as shown below.
4 Adjust the Audio item
Press the [4] or [¢] button.
Adjustment Item Display Range
Bass Center Frequency*² "Bass F" 60/70/80/100 or 150 Hz
Bass level "Bass" –8 — +8
Bass Q Factor*² "Bass Q" 1.00/1.25/1.50/2.00
Bass Extend*² "Bass EXT" ON/OFF
Middle Center Frequency*² "MID F" 0.5/1.0/1.5/2.0 kHz
Middle level "Middle" –8 — +8
Middle Q Factor*² "Middle Q" 1.0/2.0
Treble Center Frequency*² "TRE F" 10.0/12.5/15.0/17.5 kHz
Treble level "Treble" –8 — +8
Balance "Balance" Left 15 — Right 15
Fader "Fader" Rear 15 — Front 15
Sub woofer level*¹ "SW Level" –15 — +15
Front High Pass Filter*² "HPF F" Through/100/125/
170 Hz
Rear High Pass Filter*² "HPF R" THRU/200 Hz
Front/Rear High Pass Filter "HPF" THRU/100/125/170 Hz
Sub woofer Low Pass
Filter*¹
"LPF SW" 50/80/120/THRU Hz
Volume offset "V-offset" –8 — ±0
Loudness "LOUD" ON/OFF
• According to the Bass Q Factor setting value, the
frequencies that can be set in Bass Center Frequency
change as shown below.
Bass Q Factor Bass Center Frequency
1.00/1.25/1.50 60/70/80/100
2.00 60/70/80/150
• When the Bass Extend is set to ON, low frequency
response is extended by 20%.
• Volume offset: Each source’s volume can be set as a
difference from the basic volume.
• Loudness: Compensating for low and high tones
during low volume.
• *¹ You can control this item when 'Switching preout'
(page 26) is set to "SWPRE Sub-W".
• *² Function of the KDC-X579
5 Exit Audio Control mode
Press the [AUD] button.
Speaker Setting
Fine-tuning so that the System Q value is optimal
when setting the speaker type.
1 Enter Standby
Press the [SRC] button.
Select the "STANDBY" display.
2 Enter Speaker Setting mode
Press the [Q] button.
3 Select the Speaker type
Press the [4] or [¢] button.
Each time the button is pressed the setting
switches as shown below.
Speaker type Display
OFF "SP OFF"
For 5 & 4 in. speaker "SP 5/4inch"
For 6 & 6x9 in. speaker "SP 6*9/6inch"
For the OEM speaker "SP O.E.M."
4 Exit Speaker Setting mode
Press the [Q] button.
B64-2695-00_U.S(K)_02.Indd 11 03.11.18, 4:52:24 PM