Operation Manual

Adjustment Item Button Display

The panel tilts upwards [2] "ANG–"

The panel tilts downwards [3] "ANG+"

The panel slides backward [4] "SLD–"

The panel slides forward [5] "SLD+"

4 Exit Panel Position Setting mode

Press the [RTN] button.

• The control panel may be interfered with the shift lever or another

part depending on the angles of the control panel.

Set the angle to avoid any interference.

• When a hard rubber frame is mounted do not use with the panel

slid in the backward direction.

If so, the hard rubber frame will interfere with the panel when the

angle is adjusted downward.

No sound is produced while the panel is operating.

Setting the angle or back-forward position of the control panel.

Select the key function section

Press the [NEXT] button.

Repeatedly press the button until "PNL" is displayed above the [4]

button.

2 Enter Panel Position Setting mode

Press the [4] ("PNL") button.

3 Select the item for adjustment

Press the desired [2] — [5] button.

Each time the button is pressed the items that can be adjusted

switch as shown below.

Panel Position Setting

Turning the volume down quickly.

Press the [ATT] button.

Each time the button is pressed the Attenuator turns ON or OFF.

When it’s ON, "ATT ON" is displayed.

Attenuator

Increasing Volume

Turn the [VOLUME CONTROL] knob clockwise.

Decreasing Volume

Turn the [VOLUME CONTROL] knob counterclockwise.

Volume

— 11 —

KDC-PSW9524_U.S_r5.pg 02.12.13 2:05 PM Page 11