Operation Manual

Switching the information displayed in Standby.
1 Enter Standby
Press the [SRC] button.
Select the "ALL OFF" display.
The setting of this function is available while "Display Type A" is
selected for the Display mode.
2 Select the key function section
Press the [NEXT] button.
Repeatedly press the button until "DISP" is displayed above the
[3] button.
Refer to <Notes on Multi-function Key System> (page 8).
3 Enter display control mode
Press the [3] ("DISP") button.
4 Enter text select mode
Press the [3] ("TEXT") button.
5 Switch the display
Press the [4] or [¢] button.
Each time the button is pressed the display switches.
KDC-PSW9524
Information Display
Standby display & Clock "ALL OFF" & "CLOCK"
Standby display "ALL OFF"
Date & Clock "DATE" & "CLOCK"
KDC-8024
Information Display
Date & Clock "DATE" & "CLOCK"
Standby display "ALL OFF"
KDC-8024: While "Display Type C" is selected for the Display mode
the date is only displayed.
Switching the Standby Display
Function of the KDC-PSW9524
Switching the Left side graphic Display.
1 Select the key function section
Press the [NEXT] button.
Repeatedly press the button until "DISP" is displayed above the
[3] button.
Refer to <Notes on Multi-function Key System> (page 8).
2 Enter display control mode
Press the [3] ("DISP") button.
3 Switch the Left graphic part
Press the [4] ("GRPH") button.
Each time the button is pressed the Left side graphic part
switches as shown below.
Left side graphic part
Source graphic
Spectrum analyzer 1
Spectrum analyzer 2
Spectrum analyzer 3
Spectrum analyzer 4
Spectrum analyzer 5
Spectrum analyzer 6
Spectrum analyzer 7
Blank
4
Exit display control mode
Press the [RTN] button.
If <Dual Zone System> (page 26) is turned ON while the spectrum
analyzer is displayed, the left side graphic display automatically
displays the source graphic.
Left Side Graphic Display Switching
General features
— 22 —
English
KDC-PSW9524_U.S_r5.pg 02.12.13 2:05 PM Page 22