Operation Manual

32
|
KDC-BT8044U/ KDC-BT8044UY/ KDC-W7544U/ KDC-W7644UY/ KDC-W7044U/ KDC-W7144UY
Sound Setup
Audio Preset Recall
Recalling the sound setup registered by <Audio
Preset Memory> (page 32).
1 Select the source
Press the [SRC] button.
2 Enter Audio preset recall mode
Select “SOUND” > “Preset” > “Recall”.
For how to select Function Control items, refer to
<Function Control> (page 6).
3 Select the number to recall in the memory
Turn the Control knob and push the center
when the desired number is displayed.
4 Turn the Control knob to select “YES”, and then
press the Control knob.
“Recall Completed” is displayed.
5 Exit Audio preset recall mode
Press the [FNC] button.
⁄
• The “User” of <Preset Equalizer curve select> (page 30) is
changed to the value which was recalled.
• The Equalizer curve is changed to the value which was
recalled by the selected source.
Audio Preset Memory
Registering the value setup by Sound Control.
1 Setup Sound Control
Refer to the following operations to setup the
Sound Control.
- Cabin selection (page 28)
- Speaker Setting (page 28)
- DTA (Digital Time Alignment) setting (page 29)
- X’Over setting (page 29)
- Manual Equalizer Control (page 30)
- Preset position selection (page 31)
- Manual position setting (page 31)
2 Enter Audio preset memory mode
Select “SOUND” > “Preset” > “Memory”.
For how to select Function Control items, refer to
<Function Control> (page 6).
3 Select the number to put in the memory
Turn the Control knob and push the center
when the desired number is displayed.
4 Turn the Control knob to select “YES”, and then
press the Control knob.
“Memory Completed” is displayed.
5 Exit Audio preset memory mode
Press the [FNC] button.
⁄
• Register 6 pairs of Audio Preset Memory.
• Number “1”: When you press the Reset, all the sources
will be the setting value which is registered.
• Number “1” and “2”:
The memory cannot be erased by the Reset button.
• This function cannot be registered when the iPod
Equalizer set in <Preset Equalizer curve select> (page 30).