Owner's Manual

ENGLISH
35
Symptom Remedy
General
Sound cannot be heard. • Adjust the volume to the optimum level.
• Check the cords and connections.
“MISWIRING CHECK WIRING
THEN PWR ON” appears.
Turn the power off, then check to be sure the terminals of
the speaker wires are insulated properly. Turn the power
on again.
“PROTECTING SEND SERVICE”
appears.
Send the unit to the nearest service center.
Source cannot be selected. Check the [SOURCESELECT] setting. (Page
5 )
• Sound cannot be heard.
• The unit does not turn on.
• Information shown on the
display is incorrect.
Clean the connectors. (Page 31)
The unit does not work at all. Reset the unit. (Page 3)
Correct characters are not
displayed.
• This unit can only display uppercase letters, numbers,
and a limited number of symbols.
• Depending on the display language you have selected
(page 5), some characters may not be displayed
correctly.
(For
)
“SET ERROR”/“DEL ERROR”
Setting/deleting the remote control ID is unsuccessful.
Turn the power off, then turn on the power and perform
the operation again.(Page 5)
(For
)
“ERROR”/”FAILED”
Your steering remote controller is not compatible,
learning may not be completed. Consult your car audio
dealer for details.
Radio
• Radio reception is poor.
• Static noise while listening
to the radio.
Connect the antenna firmly.
TROUBLESHOOTING
Symptom Remedy
CD/USB/iPod
Disc cannot be ejected.
Press and hold
to forcibly eject the disc. Be careful not
to drop the disc when it is ejected. If this does not solve
the problem, reset the unit (page 3).
Noise is generated. Skip to another track or change the disc.
“PLEASE EJECT” appears. Reset the unit (page 3). If this does not solve the
problem, consult your nearest service center.
Playback order is not as
intended.
The playback order is determined by the order in which
files were recorded (disc) or the file name (USB).
Elapsed playing time is not
correct.
This depends on the recording process earlier (disc/USB).
“READING” keeps flashing. • Do not use too many hierarchical levels and folders.
• Reload the disc or reattach the device (USB/iPod/
iPhone).
“UNSUPPORTED DEVICE”
appears.
• Check whether the connected USB device is compatible
with this unit and ensure the file systems are in
supported formats. (Page 31)
• Reattach the USB device.
“UNRESPONSIVE DEVICE”
appears.
Make sure the USB device is not malfunction and reattach
the USB device.
“USB HUB IS NOT
SUPPORTED” appears.
This unit cannot support a USB device connected via a
USB hub.
• The source does not
change to “USB” when
you connect a USB device
while listening to another
source.
• “USB ERROR” appears.
The USB port is drawing more power than the design
limit. Turn the power off and unplug the USB device.
Then, turn on the power and reattach the USB device.
If this does not solve the problem, turn the power off and
on (or reset the unit) before replacing with another USB
device.
JS_KWD_KDC_X303_KN_EN_6th.indd 35 4/6/2018 11:26:46 AM