Owner's Manual

3
Antenna terminal
Fuse (10 A)
Wiring connection
a Brown: To connect the
KENWOOD navigation system,
refer your navigation manual
b Blue/white: To the power
control terminal when using
the optional power amplifier
or to the antenna control
terminal in the vehicle
c Light blue/yellow: To the
steering wheel remote control
adapter or to KENWOOD
Marine Remote Control
unit (optional accessory) for
d Red: Ignition 12V
e Yellow: Battery 12V
f Black: Ground
g White ª, White/black ·:
Front speaker (left)
h Gray ª, Gray/black ·:
Front speaker (right)
i Green ª, Green/black ·:
Rear speaker (left)
j Purple ª, Purple/black ·:
Rear speaker (right)
Removing the unit
Installing the unit (without mounting sleeve)
1 Remove the mounting sleeve and trim plate from the unit.
2 Align the holes in the unit (on both sides) with the vehicle
mounting bracket and secure the unit with screws (supplied/
commercially available).
Part list (supplied)
(A) Faceplate (×1)
(B) Trimplate (×1)
(C) Mounting sleeve (×1)
(D) Wiring harness (×1)
(E) Extraction key (×2)
(F) Screw (supplied for
/
/ )
M5 × 7 mm (×4)
M5 × 6 mm (×4)
M4 × 8 mm (×1)
Use only the specified screws.
Using wrong screws might damage
the unit.
If no connections are made, do not
let the wire come out from the tab.
Car fuse box
Ignition switch
Car fuse box
Battery
JS_KWD_QSG_KDC_X303_KN_EN_ff.indd 3 19/6/2018 12:27:40 PM