User manual
ENGLISH
13
Data Size: B6L (182 mm x 128 mm)
Book Size: B6L (182 mm x 128 mm)
BLUETOOTH®
Default:
XX
MIC GAIN LEVEL –10
to
LEVEL +10
(
LEVEL –4
):The sensitivity of the
microphone increases as the number increased.
NR LEVEL LEVEL –5
to
LEVEL +5
(
LEVEL 0
):Adjust the noise reduction level until
the least noise is being heard during a phone conversation.
ECHO CANCEL LEVEL –5
to
LEVEL +5
(
LEVEL 0
):Adjust the echo cancellation delay
time until the least echo is being heard during a phone conversation.
Make the settings for receiving a call
1
Press to enter Bluetooth mode.
2 Turn the volume knob to select an item (see the following table),
then press the knob.
3 Repeat step 2 until the desired item is selected or activated.
4 Press and hold to exit.
To return to the previous setting item, press .
Default:
XX
SETTINGS
AUTO ANSWER
1
to
30
:The unit answers incoming call automatically in the selected time
(in seconds).;
OFF
:Cancels.
BATTERY/
SIGNAL*
AUTO
:Shows the strength of the battery and signal when the unit detects
a Bluetooth device and the Bluetooth device is connected.;
OFF
:Cancels.
*
Functionality depends on the type of the phone used.
Make a call
You can make a call from the call history, phonebook, or dialing the
number. Call by voice is also possible if your mobile phone has the
feature.
1 Press to enter Bluetooth mode.
“(First device name)” appears.
• If two Bluetooth phones are connected, press again to switch to
another phone.
“(Second device name)” appears.
2 Turn the volume knob to select an item (see the following table),
then press the knob.
3 Repeat step 2 until the desired item is selected/activated or follow
the instructions stated on the selected item.
4 Press and hold to exit.
To return to the previous setting item, press .
CALL HISTORY
(Applicable only if the phone supports PBAP.)
1
Press the volume knob to select a name or a phone number.
• “INCOMING”, “OUTGOING”, or “MISSED” is shown on the lower part
of the display to indicate the previous call status.
• Press
DISP
to change the display category (NUMBER or NAME).
• “NO DATA” appears if there is no recorded call history.
2
Press the volume knob to call.
JS_KWD_KDC_X5200BT_EN_EN_3.indd 13JS_KWD_KDC_X5200BT_EN_EN_3.indd 13 8/21/2017 2:11:48 PM8/21/2017 2:11:48 PM