Owner's Manual
Table Of Contents
- Instruction Manual
- Reset
- Bluetooth PIN (0000)
- Clock Set
- Demo Mode
- Initial Settings
- Attaching / Removing Faceplate
- Table of Contents
- Parts & Controls
- Basic Operation
- Getting Started
- HD Radio Tuner Operation (KDC-X702 / KDC-BT772HD)
- Radio Operation
- CD / USB / iPod / Android Operation
- AUX Input
- Pandora
- iHeartRadio
- Spotify
- SiriusXM
- Bluetooth
- Audio Settings
- Display Settings
- Troubleshooting
- Messages
- Specs
- Installation / Connection
- The face-fixing screw is taped to the plastic bag around radio inside the box [IMAGE]
ENGLISH
25
BLUETOOTH®
VOICE
Speak the name of the contact you want to call or the voice command to
control the phone functions.
( Make a call using voice recognition)
BATTERY LVL LOW
/
MID
/
FULL
*
:Shows the strength of the battery.
NO SIGNAL
/
SIGNAL LVL
LOW
/
MID
/
MAX
*
:Shows the strength of the current received signal.
*
Functionality depends on the type of the phone used.
Make a call using voice recognition
1
Press and hold to activate the voice recognition of the
connected phone.
2 Speak the name of the contact you want to call or the voice
command to control the phone functions.
• Supported Voice Recognition features vary for each phone. Refer to the
instruction manual of the connected phone for details.
• This unit also supports the intelligent personal assistant function of
iPhone.
Settings in memory
Store a contact in memory
You can store up to 6 contacts into the number buttons (1 to 6).
1 Press to enter Bluetooth mode.
2 Turn the volume knob to select
[CALL HISTORY]
,
[PHONE BOOK]
, or
[NUMBER DIAL]
, then press the knob.
3 Turn the volume knob to select a contact or enter a phone number.
If a contact is selected, press the volume knob to show the phone
number.
4 Press and hold one of the number buttons (1 to 6).
“STORED” appears when the contact is stored.
To erase a contact from the preset memory, select
[NUMBER DIAL]
in step 2
and store a blank number.
Make a call from memory
1
Press to enter Bluetooth mode.
2 Press one of the number buttons (1 to 6).
3 Press the volume knob to call.
“NO MEMORY” appears if there is no contacts stored.
Other settings
1
Press the volume knob to enter
[FUNCTION]
.
2 Turn the volume knob to select an item (see the following table),
then press the knob.
3 Repeat step 2 until the desired item is selected/activated or follow
the instructions stated on the selected item.
4 Press and hold to exit.
To return to the previous setting item, press
.
Default:
XX
BT MODE
PHONE SELECT
Selects the phone or audio device to connect or disconnect.
“
*
” appears in front of the device name when connected.
“
” appears in front of the current playback audio device.
•
You can only connect a maximum of two Bluetooth phones and one
Bluetooth audio device at any time.
AUDIO SELECT
DEVICE DELETE
1
Turn the volume knob to select a device to delete, then press the
knob.
2
Turn the volume knob to select
[YES]
or
[NO]
, then press the knob.
PIN CODE EDIT
(0000)
Changes the PIN code (up to 6 digits).
1
Turn the volume knob to select a number.
2
Press
S
/
T
to move the entry position.
Repeat steps
1
and
2
until you finish entering the PIN code.
3
Press the volume knob to confirm.
JS_KWD_KDC_X702_KN_EN_9.indd 25 7/14/2017 2:20:37 PM