Owner's Manual
Table Of Contents
- Instruction Manual
- Reset
- Bluetooth PIN (0000)
- Clock Set
- Demo Mode
- Initial Settings
- Attaching / Removing Faceplate
- Table of Contents
- Parts & Controls
- Basic Operation
- Getting Started
- HD Radio Tuner Operation (KDC-X702 / KDC-BT772HD)
- Radio Operation
- CD / USB / iPod / Android Operation
- AUX Input
- Pandora
- iHeartRadio
- Spotify
- SiriusXM
- Bluetooth
- Audio Settings
- Display Settings
- Troubleshooting
- Messages
- Specs
- Installation / Connection
- The face-fixing screw is taped to the plastic bag around radio inside the box [IMAGE]
36
TROUBLESHOOTING REFERENCES
Maintenance
Cleaning the unit
Wipe off dirt on the faceplate with a dry silicone or soft cloth.
Cleaning the connector
Detach the faceplate and clean the connector
gently with a cotton swab, being careful not to
damage the connector.
Handling discs
•
Do not touch the recording surface of the disc.
•
Do not stick tape etc. on the disc, or use a disc with tape stuck on it.
•
Do not use any accessories for the disc.
•
Clean from the center of the disc and move outward.
•
Clean the disc with a dry silicone or soft cloth. Do not use any solvents.
•
When removing discs from this unit, pull them out horizontally.
•
Remove burrs from the center hole and disc edge before inserting a disc.
More information
For: – Latest firmware updates and latest compatible item list
– KENWOOD original application
– Any other latest information
Visit <www.kenwood.com/cs/ce/>.
General
•
This unit can only play the following CDs:
•
For detailed information and notes about the playable audio files, visit
<www.kenwood.com/cs/ce/audiofile/>.
Connector (on the reverse
side of the faceplate)
Symptom Remedy
Bluetooth®
“DEVICE FULL” The number of registered devices has reached its limit.
Retry after deleting an unnecessary device.
( 25,
DEVICE DELETE)
“N/A VOICE TAG” Make sure the same voice as the registered voice tag is used.
“NOT SUPPORT” The connected phone does not support Voice Recognition
feature or phonebook transfer.
“NO ENTRY”/“NO PAIR” There is no registered device connected/found via Bluetooth.
“ERROR” Try the operation again. If “ERROR” appears again, check if
the device supports the function you have tried.
“NO INFO”/“NO DATA” Bluetooth device cannot get the contact information.
“HF ERROR XX”/
“BT ERROR”
Reset the unit and try the operation again. If this does not
solve the problem, consult your nearest service center.
“SWITCHING NG” The connected phones might not support phone switching
feature.
ENGLISH
JS_KWD_KDC_X702_KN_EN_9.indd 36 7/14/2017 2:20:39 PM