Owner's Manual

40
Do the required wiring.
( 41)
Dashboard of
your car
Bend the appropriate tabs to hold the
mounting sleeve firmly in place.
How to remove the unit
1 Detach the faceplate.
2 Fit the catch pin on the extraction keys into
the holes on both sides of the trim plate, then
pull it out.
3 Insert the extraction keys deeply into the slots
on each side, then follow the arrows as shown
on the illustration.
Installing the unit (in-dash mounting)
When installing without the mounting
sleeve
1 Remove the mounting sleeve and trim plate from
the unit.
2 Align the holes in the unit (on both sides) with
the vehicle mounting bracket and secure the unit
with screws (supplied/commercially available).
Use only the specified screws. Using wrong screws
might damage the unit.
Hook on the top side
Orientate the trim plate
as illustrated before
fitting.
INSTALLATION/CONNECTION
Basic procedure
1 Remove the key from the ignition switch, then disconnect the
[ terminal of the car battery.
2 Connect the wires properly.
See Wiring connection.
( 41)
3 Install the unit to your car.
See Installing the unit (in-dash mounting).
4 Connect the [ terminal of the car battery.
5 Press to turn on the power.
6 Detach the faceplate and reset the unit within 5 seconds. ( 3)
Part list for installation
(A) Faceplate
(C) Mounting sleeve
(B) Trim plate
(D) Wiring harness
(E) Extraction key (F) Screws (supplied for
/ )
ENGLISH
JS_KWD_KDC_X702_KN_EN_9.indd 40 7/14/2017 2:20:41 PM