User's Manual

INSTALLATION
3. Ignition Sense Cable (KCT-18 : Option)
The KCT-18 is an optional cable for enabling the
ignition function. The ignition function lets you turn the
@
power to the transceiver on and off with the car ignition
1
i
key.
I
j
If you use the Horn Alert function (KDD-4 requ~red)
or the Manual Relay function, you can turn the function
, I
1
off while driving with the ~gnit~on key.
t
1
k
3-1. Connecting the KCT-18 to the transceiver
k
1. Install the KCT-19 in the transceiver (See the KCT-
B.
19 section.) 1
p
2. Insert the KCT-18 lead terminal (Q) into pin 3 of the
I
square plug (0 supplied with the KCT-19, theri t
insert the square plug into the KCT-I9 connector
(0 1.
3-2. Modifying the transceiver
Modify the transceiver as follows to turn the power
ontact
or the Horn Alert or Manual Relay function on and off
1
with the ignition key. "$/ i
1. Remove the lower half of the transceiver case.
KCT- 18
2. Set jumper resistors (On) R5 and R6 of the TX-RX
Fig. 8
t
r
i
unit (A/2) as shown in Table 2.
- -
t KCT-18 cannot be connected
+- Power cannot be turned on
Table 2 R5 and R6 setup chart
Thr ,-+- - 'Alert or Manu2: Relay function can be turned on and off only if the function has been
as - to the AUX ',:i..i
.-