User's Manual

Subcode editing
• To manually write a ST-ID during recording
• In situations such as when recording an audio source that has no space between tunes,
you can manually write ST -IDs
in the appropriate locations while recording is being carried
out.
• After writing a ST-ID, you must wait at
least 9 seconds before writing the next
ST-ID.
• You cannot write more than
99 tune
numbers.
• If no tune number
is displayed, writing a
ST-ID will not switch to the next tune num-
ber. Renumber the tunes after recording
is finished.
(See page 25.)
• To add a ST-ID to a previously recorded tape
• If the displayed tune number does not change when tunes change during playback, no ST-
ID
is recorded at that location. In such a case, use the following procedure to add the neces-
sary ST-ID.
• The unit enters ST-ID
record-standby mode
and the following oper-
ation occurs.
• After three seconds of
playback, the tape auto-
matically rewinds to a
position
two seconds
before the start position.
(This
is repeated up to
10 times.)
Display example
Use the [REW] and [FA
buttons to move the tape
to the start position.
REW FF
At the start posi-
tion, press the
(REGl button again.
• Each time one of these
buttons
is pressed, the
position where the ST-
I D indicator lights is
moved forward or back-
ward by
0.3 second.
(1.8 seconds max.)
• The
ST -I D is written on
the tape and then play-
back continues.
TiT)
(REW)I-l-I (FF)A
0.3 sec.C.3 sec.
/-
(Lights) (Lights)
'~'ID~ •
-,.-, ,
.J·C 0
• Leave at least 9 seconds between ST-IDs.
• Tune numbers
do not change automatically when a ST-ID is added. After adding all neces-
sary ST-IDs, renumber the tunes. (See page
25.)
24 DX-7