Operating Instructions and Installation Instructions

16
PROGRAM FOR AUTOMATIC
SWITCHING OFF OF A COOKING
ZONE
This function permits to set a timer from “ 1 ”
to “ 99 ” minutes for automatic turning Off the
cooking zone/s.
With the cooktop switched On:
• Select the cooking zone and set the
desired power level.
• Within 8 seconds, touch the timer key
“
CL ” (the led indicating the programmed
zone starts blinking) and set the timer:
– The display reads “
0- ”: set the
second digit of the timer by using
the setting selector. If the value shall
be zero touch the display and the
second digit ( 0 ) will start ashing.
Touch the display to conrm o wait
a few seconds till the programmer
automatically turns to the next step.
– When the display reads “ -Z ” (where “ Z
” indicates the second digit previously
set): set the rst digit of the timer by
using the setting selector. If the value
shall be zero touch the display and
the rst digit ( 0 ) will start ashing.
Touch the display to conrm o wait
a few seconds till the programmer
automatically turns to the next step.
– The program is now processed (led
indicating the programmed zone
steady lit).
• The time can be changed at any time
following the same procedure here
above indicated (selecting previously the
cooking zone).
• To program another cooking zone,
repeat as described above.
Now the program for automatic switching Off
is complete.
At the end of the countdown the cooking
zone will switch Off automatically, an acoustic
signal (beep) will sound (for 2 minute only),
“
00 ” will ash on the timer display and the
led next to the heater display will blink.
Touch one of the keys to stop the beep.
Fig. 2.6
Fig. 2.7
Fig. 2.8
Fig. 2.9