Owner's Manual

28
TROUBLESHOOTING SPECIFICATIONS
Tuner
FM Frequency Range 87.9MHz — 107.9MHz
(200 kHz space)
Usable Sensitivity
(S/N=26dB)
8.2dBf (0.71μV/75Ω)
Quieting Sensitivity
(DINS/N=46dB)
17.2dBf (2.0μV/75Ω)
Frequency Response
(±3dB)
30Hz — 15kHz
Signal-to-Noise Ratio
(MONO)
64dB
Stereo Separation (1kHz) 40dB
AM Frequency Range 530kHz — 1700kHz (10kHz space)
Usable Sensitivity
(S/N=20dB)
29dBμ (28.2μV)
CD player
Laser Diode GaAIAs
Digital Filter (D/A) 8 times over sampling
Spindle Speed 500rpm — 200rpm (CLV)
Wow & Flutter Below measurable limit
Frequency Response (±1dB) 20Hz — 20kHz
Total Harmonic Distortion
(1kHz)
0.01%
Signal-to-Noise Ratio (1kHz)
: 110dB
/ :
105dB
Dynamic Range 90dB
Channel Separation 85dB
Symptom Remedy
Bluetooth®
Echo or noise is heard during
a phone conversation.
•
Adjust the microphone unit’s position. (  15 )
•
Check the [ ECHO CANCEL ] setting. (  17 )
Phone sound quality is
poor.
•
Reduce the distance between the unit and the Bluetooth device.
•
Move the car to a place where you can get a better signal
reception.
Voice calling method is not
successful.
•
Use voice calling method in a more quiet environment.
•
Reduce the distance from the microphone when you speak the
name.
•
Make sure the same voice as the registered voice tag is used.
Sound is being interrupted
or skipped during playback
of a Bluetooth audio player.
•
Reduce the distance between the unit and the Bluetooth audio
player.
•
Turn off, then turn on the unit and try to connect again.
•
Other Bluetooth devices might be trying to connect to the unit.
The connected Bluetooth
audio player cannot be
controlled.
•
Check whether the connected Bluetooth audio player supports
Audio/Video Remote Control Profile (AVRCP). (Refer to the
instructions of your audio player.)
•
Disconnect and connect the Bluetooth player again.
“DEVICE FULL” The number of registered devices has reached its limit. Retry after
deleting an unnecessary device. (
 19 , DEVICE DELETE )
“N/A VOICE TAG” Make sure the same voice as the registered voice tag is used.
“NOT SUPPORT” The connected phone does not support Voice Recognition feature or
phonebook transfer.
“NO ENTRY” / “NO PAIR” There is no registered device connected/found via Bluetooth.
“ERROR” Try the operation again. If “ERROR” appears again, check if the
device supports the function you have tried.
“NO INFO” / “NO DATA” Bluetooth device cannot get the contact information.
“HF ERROR XX” /
“BT ERROR”
Reset the unit and try the operation again. If this does not solve the
problem, consult your nearest service center.
JS_KWD_KDC_X500_KW_EN_00_2.indd 28 10/7/2015 5:02:06 PM