Operation Manual

27
7 - ELECTRICAL INSTALLATION
The appliance must be connected to the electrical network verifying that the voltage corre-
sponds to the value indicated on the specifications plate and that the cables section of the
electrical wiring can bear the load which is indicated on the rating plate.
We recommend that the appliance is connected by a suitably qualied person who will
comply with the current IEE and local regulations.
The appliance must be connected via 13 Amp switched fuse spur, with a minimum opening
between the contacts of 3 mm.
The appliance must be connected to a SWITCHED FUSED SPUR OUTLET, similar to
that shown in Fig. 7.1 and should be accessible and no more than 2 metres away from the
appliance.
Alternative connection methods may be available as long as they conform to current IEE
wiring regulations.
The power supply cable must not touch the hot parts and must be positioned so that it does
not exceed 75°C at any point.
Once the cooker has been installed, the switch must always be accessible.
IMPORTANT: The appliance must be installed in accordance with the manufacturer’s
instructions. Incorrect installation, for which the manufacturer accepts no
responsibility, may cause damage to persons, animals and property.
The connection of the appliance to earth is mandatory. The manufacturer declines
all responsibility for any inconvenience resulting from the inobservance of this
condition.
Before carrying out any work on the electrical parts of the appliance, the appliance
must be disconnected and locked off from the mains.
FUSE
SWITCHED FUSED
SPUR OUTLET
Use a suitable FUSE in accordance
with the appliance power rating
ON
Fig. 7.1