Operation Manual

28
230 V
E
N
L
E Earth
N Neutral
L Live
ELECTRICAL FEEDER CABLE CONNECTION
WARNING: If the power supply cable is damaged, it must be replaced only by an
authorised service agent in order to avoid a hazard.
To connect the supply cable:
• Unhook the terminal board cover by inserting a screwdriver into the two hooks “A”
(gure 7.2).
• Open the cable gland by unscrewing screw “F” (g. 7.3), unscrew the terminal screws
and remove the cable.
• The new supply cable, of suitable type and section, is connected to the terminal board
following the diagram of g. 7.4.
NOTE: The earth conductor must be left about 3 cm longer than the others.
POWER SUPPLY
230 V~ 50 Hz 2350 W
FEEDER CABLE SPECIFICATIONS
Type “H05RR-F”
3 x 1,5 mm
2
A
F
Fig. 7.4
Fig. 7.3Fig. 7.2