Datasheet

ManualsBrandsKenwood ManualsAccessoriesQuick Charger

Table Of Contents

SERVICE MANUAL

This product uses Lead Free solder.

This product complies with the

RoHS

directive for the European market.

B53-7051-00

(

)

PDF

KSC-43

RAPID CHARGER

PARTS LIST ..............................................................................................2

SPECIFICATIONS .....................................................................................

TROUBLE SHOOTING .............................................................................3

CONTENTS

Charger assy

(W08-1331-05)

Summary of content (4 pages)

PAGE 1
RAPID CHARGER KSC-43 SERVICE MANUAL © 2013-2 PRINTED IN JAPAN B53-7051-00 (Y) PDF Charger assy (W08-1331-05) CONTENTS PARTS LIST .............................................................................................. 2 SPECIFICATIONS ..................................................................................... 2 TROUBLE SHOOTING ............................................................................. 3 This product complies with the RoHS directive for the European market.
PAGE 2
KSC-43 Document Copyrights Disclaimer Copyright 2013 by JVC KENWOOD Corporation. All rights reserved. No part of this manual may be reproduced, translated, distributed, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, for any purpose without the prior written permission of JVC KENWOOD Corporation. While every precaution has been taken in the preparation of this manual, JVC KENWOOD Corporation assumes no responsibility for errors or omissions.
PAGE 3
KSC-43 TROUBLE SHOOTING This flow chart checks whether the charger is faulty. (The battery is installed in the charger.) START The LED lights red or green. LED check The charger is normal. The LED does not light, or the LED blinks red. Is there contact with the T terminal? No Contact the T terminal again, or replace the T terminal. No The charger is abnormal. Replace the charger. Yes Is the voltage of B+ terminal 8.7V(Li-ion)/ 9.4V(Ni-MH)? Yes When an abnormal condition is confirmed.
PAGE 4
KSC-43