MONITOR WITH DVD RECEIVER KVT-526DVD KVT-556DVD INSTALLATION MANUAL © B54-4749-00/00 (EW/QW) B54-4749-00_00_KVT-526DVD_En.indd 1 09.10.
Installation Procedure/Accessories 1. To prevent short circuits, remove the key from the ignition and disconnect the - terminal of the battery. 2. Make the proper input and output wire connections for each unit. 3. Connect the wire of the wiring harness. 4. Take Connector B on the wiring harness and connect it to the speaker connector in your vehicle. 5. Take Connector A on the wiring harness and connect it to the external power connector on your vehicle. 6. Connect the wiring harness connector to the unit.
Connecting Wires to Terminals Connector Function Guide Pin Numbers for ISO Connectors External Power Connector A-4 A-5 A-6 A-7 A-8 Cable Colour Functions Yellow Blue/White Orange/White Red Black Battery Power Control Dimmer Ignition (ACC) Earth (Ground) Connection Speaker Connector B-1 B-2 B-3 B-4 B-5 B-6 B-7 B-8 Purple Purple/Black Gray Gray/Black White White/Black Green Green/Black Rear Right (+) Rear Right (–) Front Right (+) Front Right (–) Front Left (+) Front Left (–) Rear Left (+) Rear Left (–
Connecting Wires to Terminals USB connector USB device (commercially available) Connector A Battery wire (Yellow) 8 7 6 5 4 3 2 1 Ground wire (Black) 8 7 6 5 4 3 2 1 Ignition wire (Red) FUSE ( 15A ) Connector B Connect to the vehicle's parking brake detection switch harness. Parking sensor wire (Light Green) PRK SW For the sake of safety, be sure to connect the parking sensor. Connect to vehicle’s reverse lamp harness when using the optional rear view camera.
Cooling fan Antenna Cord FM/AM antenna input (JASO) Wiring harness (Accessory 1) Wiring harness (Accessory 2) AV IN REAR VIEW CAMERA REVERSE AV OUT REMOTE CONT STEERING WHEEL REMOTE INPUT Audio/Visual input / Rear View Camera Input • Visual input (Yellow) • Audio left input (White) • Audio right input (Red) Audio/Visual Output • Visual output (Yellow) • Audio left output (White) • Audio right output (Red) REAR/SUB WOOFER Rear/Subwoofer Preout • Audio left output (White) • Audio right output (Red)
Optional Accessory Connection iPod (commercially available) iPod AUDIO IN KCA-iP301V (Optional Accessory) Audio Input Resistance-free stereo type mini plug (3.5Ф) Audio Output (Black) Visual Input (Yellow) Resistance-free mini plug (3.
Installation/Removing the Unit Installation Bend the tabs of the mounting sleeve with a screwdriver or similar utensil and attach it in place. Make sure that the unit is installed securely in place. If the unit is unstable, it may malfunction (eg, the sound may skip). English | B54-4749-00_00_KVT-526DVD_En.indd 7 7 09.10.
Installation/Removing the Unit Removing the Hard Rubber Frame (escutcheon) 1. Engage the catch pins on the removal tool 3 and remove the two locks on the lower level. Lower the frame and pull it forward as shown in the figure. Removing the Unit 1. Remove the hard rubber frame by referring to the removal procedure in the section . 2. Insert the two removal tools 3 deeply into the slots on each side, as shown.