MZ360229EX (LZH-80WM4) OVERHEAD CONSOLE WITH 8” LCD SCREEN INSTRUCTION MANUAL © B64-3764-00/00 (WW) LZH-80̲Eng̲r1.indd 1 07.2.
Safety precautions Notes 2 WARNING • The illustrations of the display and the panel appearing in this manual are examples used to explain more clearly how the controls are used. Therefore, what appears on the display in the illustrations may differ from what appears on the display on the actual equipment, and some of the illustrations on the display may represent something impossible in actual operation.
Components names and Functions 1 2 3 Open the monitor 4 1 Monitor release knob Unlock the motor. 2 Dome light switch "ON": The light goes on. "DOOR": The light does on/out with the opening/closing of vehicle doors. "OFF": The light goes out. 3 IR transmitter 4 Audio/ Visual input 2 terminal • Visual input (Yellow) • Audio left input (White) • Audio right input (Red) Monitor release knob 1 Unlock the motor Press the monitor release knob. 2 Open the monitor Press the monitor dawnward.
Operations SCRN INPUT POWER INPUT /MENU POWER Power DIM DIM/ SCRN/ Display information Turns power ON or OFF Press the [POWER] button. When you press the [INPUT] button, the status of the monitor is displayed. 3 AV-IN2 Video Source Selection Press the [INPUT] button. Each time the button is pressed, the video source switches as follows: Display "AV-IN1" "AV-IN2" Setting Select the AV1 INPUT source. Select the AV2 INPUT source.
Picture Quality setting ⁄ You can adjust the picture quality control of the monitor. • The "TIN" can be adjusted when NTSC video signal is input. • The screen select can be set for each source. • If you make no operation for 15 seconds, this mode is automatically canceled. 1 Enter Picture Quality setting mode Press the [MENU] button for at least 2 seconds. 2 Select the screen for brightness ("BRT") setting Press the [SCRN] or [DIM] button for at least 2 seconds.
Operations Switching Screen mode Press the [SCRN] button. Each time the button is pressed, the screen mode switches as follows: Display "Full" Setting Full picture mode. "Just" Justify picture mode. IR Headphones frequency setting You can select the IR Headphones frequency you wish. Press the [SCRN] button for at least 2 seconds. Each time the button is pressed for at least 2 seconds, the frequency output switches as follows: Display "2 MHz" "3 MHz" "Cinema" Cinema picture mode.
Specifications Specifications subject to change without notice. Monitor Unit Screen size : 8 inches wide Display system : Transparent TN LCD panel Drive system : TFT active matrix system Number of pixels : 336,960 pixels (480 H × 234 V × RGB) Effective pixels : 99.99 % Pixel arrangement : RGB striped arrangement Back lighting : Cold cathode tube IR Transmitter Output : (2MHz) L ch: 2.3 MHz/ R ch: 2.8 MHz : (3MHz) L ch: 3.2 MHz/ R ch: 3.
LZH-80̲Eng̲r1.indd 8 07.2.
