Operation Manual

BASIC OPERATIONS

SWITCHING POWER ON/OFF

Turn the Power switch/ Volume control clockwise to switch the

transceiver ON.

Turn the Power switch/ Volume control counterclockwise fully

to switch the transceiver OFF.

■ Transceiver Password

(NX-200/ NX-300/ NX-200G/ NX-300G Only)

If the transceiver is password protected, “PASSWORD” will

appear on the display when the power is turned ON. To

unlock the transceiver, enter the password:

1 Select a character using / .

• On keypad models, you can enter the password directly.

2 Press to enter the selected character.

• This step is unnecessary when using the keypad.

3 Repeat steps 1 and 2 to enter the entire password.

• Press or # to delete a character. Press and hold or

# to delete all characters.

4 Press or to confirm the entry.

• If you enter an incorrect password, an error tone sounds

and the transceiver remains locked.

• The password can contain a maximum of 6 digits.

ADJUSTING THE VOLUME

Rotate the Power switch/ Volume control to adjust the volume.

Clockwise increases the volume and counterclockwise

decreases it.

SELECTING A ZONE AND CHANNEL/GROUP ID

Select the desired zone using the key programmed as Zone

Select or Zone Up/Down. Each zone contains a group of

channels.