Operation Manual
32
VGS-1 OPTIONAL VOICE GUIDE & STORAGE UNIT
VOICE RECORDER
The voice recorder allows you to record conversations and
create voice memos.
■ Auto Recording (NX-200/ NX-300/ NX-200G/ NX-300G Only)
If activated, the auto recorder will continuously record all
transmitted and received signals. The recording storage
area retains only the last 30 seconds of recording.
■ Voice Memos (NX-200/ NX-300/ NX-200G/ NX-300G Only)
To record a voice memo for later playback:
1 Press the key programmed as Voice Memo, press and
hold the key programmed as Playback, or access the
Menu {page 15}.
• The duration of recording memory will appear on the
display and begin counting down.
2 Speak into the microphone to record your memo.
3 Press to end the recording and store it in memory.
• If the memory becomes full, recording will stop and the
voice memo will be stored in memory.
■ Auto Reply Message
(NX-200/ NX-300/ NX-200G/ NX-300G Only)
You can set the transceiver to automatically respond to
Individual Calls while using FleetSync/NXDN.
1 Press the key programmed as Auto Reply Message to
enter Auto Reply Message mode.
2 When you receive an Individual Call, the transceiver will
send an automatic response to the caller after
3 seconds, and “GREETING” appears on the display.
• If you are available to receive the call, press any key to
cancel the auto response.
• If there is memory available on your transceiver, “I am not
available. Leave your Message.” will be sent to the caller