Operation Manual

Note:

◆ When Activity Detection has been turned off, and the

transceiver power is then turned off and back on, Activity

Detection is automatically enabled.

◆ When using this function, verify that it operates before

taking the transceiver.

■ Activity Reset

While Activity Detection is active, press the key

programmed as [Activity Reset] to reset the Activity

Detection countdown timer. This will allow you to remain in

a tilted or stationary position, etc., without the Emergency

mode activating unnecessarily.

SCRAMBLER

Press the key programmed as [Scrambler/ Encryption], to

switch the transceiver to secure (encrypted) transmission.

• Pressing the PTT switch after the Scrambler function has been

turned ON encrypts the transmitted signal.

Note: This function cannot be used in certain countries. Contact

your Kenwood dealer for further information.

SIGNALING

■ Quiet Talk (QT)/ Digital Quiet Talk (DQT)

Your dealer may have programmed QT or DQT signaling on

your transceiver channels. A QT tone/ DQT code is a

sub-audible tone/code which allows you to ignore (not hear)

calls from other parties who are using the same channel.

Operator Selectable Tone (OST) (Types I and II Only)

If a key has been programmed with [OST], you can

reprogram the QT/DQT settings on each of your channels.

1 Select your desired channel.

2 Press and hold the key programmed as [OST] for

1 second.

Press the <B or C> key to select your desired tone or code.

• Your dealer can set up to 40 tones/codes.