Operation Manual

2
PREPARATION
INSTALLING THE CHANNEL STOPPER
You can set the channel stopper position for channels 2, 4,
6, 8, 10, 12, and 14. Inserting the Channel stopper prevents
unnecessarily selecting channels which do not exist.
• Selecting a channel which does not exist causes a continuous error
tone to sound.
1 Set the Channel selector to channel 1, then pull the
Channel selector knob off the transceiver.
• If the Channel selector is not positioned at channel 1, the knob may
not install correctly and the channel may be unable to change.
2 Insert the channel stopper.
3 Set the arrow of the Channel stopper to the highest channel
number for the transceiver.
4 Reinsert the Channel selector knob.
Screw the antenna into the connector on the
top of the transceiver by holding the antenna at
its base and turning it clockwise until secure.
Note:
◆ The antenna is neither a handle, a key ring
retainer, nor a speaker/ microphone attachment
point. Using the antenna in these ways may
damage the antenna and degrade your
transceiver’s performance.
INSTALLING THE ANTENNA
Channel stopper
Arrow
Antenna