Operation Manual
VOICE OPERATED TRANSMISSION (VOX)
VOX can be activated or deactivated by your dealer. VOX operation allows you to
transmit hands-free.
Note:
◆
To operate VOX on a Portable transceiver, you must use an optional headset.
◆
To operate VOX on a Mobile transceiver, you must use an optional headset connected
via the Bluetooth Headset Profile. Refer to “Bluetooth” {p. 56} .
Microphones such as KMC-28 cannot be used to operate VOX.
o
VOX Gain Level
Sets the Mic input sensitivity of the VOX operation.
1
Connect a headset to the transceiver.
2
Press the button programmed as [VOX].
●
The current VOX Gain level appears on the display.
3
Press the [J] or [K] button to increase or decrease the VOX Gain level.
●
The VOX Gain can be adjusted from levels 1 to 10.
4
While adjusting the level, speak into the headset microphone to test the sensitivity
level. (Your voice is not transmitted during this test procedure.)
●
When sound is recognized, the LED lights yellow.
5
Press the [
] button to save your new setting.
o
VOX Operation
1
Connect a headset to the transceiver.
●
The VOX function does not activate when a headset is not connected to the accessory
terminal of the transceiver.
2
Press and hold the button programmed as [VOX].
●
Alternatively, you can press the button programmed as [Menu] to enter VOX Mode
using the Menu Mode.
●
A beep will sound and the
indicator appears on the display.
3
When you finish speaking, transmission ends.
To turn the VOX function OFF, press and hold the button programmed as [VOX] button
again.
●
A beep will sound and the
indicator will disappear from the display.
Note:
●
If a speaker/ microphone is connected to the transceiver while VOX is ON, and the VOX
Gain Level is set to a sensitive level, louder received signals may cause the transceiver
to transmit.
52