Operation Manual
o
Making Group Calls (NXDN Trunking/ DMR Trunking)
You can select a channel with the Group ID you wanted to call to make a call to those
parties on a Trunking channel.
●
If the traffic channel is busy, a busy message appears and the busy tone sounds. Release
the PTT switch and wait for the channel to become free. When the traffic channel becomes
free, a proceed tone sounds.
1
Select the configured Group channel using the buttons programmed as [Channel
Up]/ [Channel Down].
2
Press and hold the PTT switch to make the call.
●
“Calling” appears on the display while the call is being made, and disappears once
the call is established.
●
Speak into the transceiver as you would during a normal call.
o
Making Individual Calls (NXDN Trunking/ DMR Trunking)
You can make calls to specific persons on a Trunking channel.
1
Press the button programmed as [Individual], [Individual + Short Message]
or [Individual + Status] to enter Individual Call Mode.
Alternatively, press the button programmed as [Menu] to enter Individual Call Mode using
the Menu Mode.
●
The ID list appears on the display.
2
Press the [J] and [K] buttons to select a unit ID from the list that has been pre-
entered into your transceiver.
Alternatively, on full button model Portable transceivers or Mobile transceivers with
microphone with keypad, you can enter a unit ID directly by pressing the keypad.
●
Press the [ ] button to enter the manual input mode.
To delete the ID entered, press the [ ] button to delete one digit, or press and hold
the [
] button to delete all digits.
3
Press and hold the PTT switch to make the call.
●
“Calling” appears on the display while the call is being made, and disappears once
the call is established.
●
Speak into the transceiver as you would during a normal call.
7