Operation Manual

o
Scan Program <ScnPrg>
Allows you to reprogram the Scan List and Priority channels using your transceiver.
Refer to “SCAN PROGRAMMING” {p. 32} .
o
Scrambler/ Encryption <Scr/ Encryp>
Allows you to prevent a third party from listening in on your call. Refer to
“SCRAMBLER (ANALOG)/ ENCRYPTION (P25/ NXDN)” {p. 38} .
o
Scrambler/ Encryption Code
Allows you to change the scrambler code used in the transmission. Refer to
“SCRAMBLER (ANALOG)/ ENCRYPTION (P25/ NXDN)” {p. 38} .
o
Send the GPS Data <GPS_TX>
Allows you to send your positioning data to the base station when a GPS unit has
been installed.
o
Short Message <SDM>
Allows you to send short messages such as an address, telephone number, etc.
o
Site Down <Site－>
Press this key to decrease the site number.
o
Site Lock <SiteLk>
Allows you to lock the current site. The transceiver will not be able to search for
alternate sites, and “Site Lock” appears on the display.
o
Site Number
This displays the site number.
o
Site Select
Allows you to select the site to lock.
o
Site Up <Site+>
Press this key to increase the site number.
o
Speaker Attenuation
Press this key to attenuate received voice signals. This reduces the strength of the
speaker output to cut back any noise and distortion present in the signal.
o
Speaker Type
Allows you to select a speaker type that suits the optional external speaker
connected.
o
Squelch Level <SQL>
Allows you to adjust the transceiver squelch level.
When adjusting the squelch level, use the [J] and [K] keys to increase and decrease
the squelch level from 0 (open) to 9 (tight). The default setting is 5.
28