Operation Manual

STATUS MESSAGE
You can send and receive 2-digit Status messages which may be decided in your
talk group. Messages can contain up to 16 alphanumeric characters. Status
messages range from 10 to 99 (80 ~ 99 are reserved for special messages).
A maximum of 32 received messages can be stored in the stack memory of your
transceiver. These saved messages can be reviewed after reception. Depending on
your dealer settings, when the stack memory is full, either the oldest message will be
erased when a new message is received or the new message will not be stored in
the stack memory. The indicator appears when a message is stored in the stack
memory.
o
Transmitting
1
Select your desired zone and channel.
2
Press the key programmed as [Status] to enter Status mode (proceed to step
5), or [Individual + Status]/ [Group + Status] to enter Selcall mode (proceed
to step 3).
3
Press the [J] and [K] keys to select the station you want to call.
●
If Manual Dialing is enabled, you can enter a station ID using the keypad or the [J]/[K]
key. When using the [J] and [K] keys, cycle through the digits to select a digit, then
press the [ ] or [ ] key to set the digit and move the cursor to the right. Repeat this
process until the entire ID is entered.
4
Press the [I] key to enter Status mode.
5
Press the [J] and [K] keys to select the status you want to transmit.
●
If Manual Dialing is enabled, you can enter a status ID using the DTMF keypad or the
[J]/[K] key (refer to step 3, above).
6
Press the PTT switch to initiate the call.
●
“Complete” appears on the display when the status has been successfully transmitted.
o
Receiving
The indicator will flash and a calling ID or text message will appear when a Status
call is received. Press any key to return to normal operation.
o
Reviewing Messages in the Stack Memory
1
Press the key programmed as [Stack], or press and hold the key programmed
as [Individual], [Group], [Status], [Individual + Status], or [Group +
Status] to enter Stack mode.
●
The last received message is displayed.
2
Press the [J] and [K] keys to select the desired message.
●
Message types are identified as follows:
: Caller ID, : Status Message, : Short Message
●
Press the [I] key to cycle the display information as follows:
Status/ Short Message ＞ Time Stamp ＞ CH ＞ Caller ID
●
Press the [H] key to cycle the display information as follows:
Status/ Short Message ＞ Caller ID ＞ CH ＞ Time Stamp
48