Product Manual

9
BASIC OPERATIONS
POWER AND VOLUME
1 Hold the Power switch for approximately 1 second to switch
the transceiver power ON.
• AbeepsoundsandtheLEDindicatorblinksblueanumberof
times as described in the “BATTERY LEVEL GUIDE” table on
page 10.
• ToturnthepowerOFF,holdthePower switch for 2 seconds.
2 In Volume Adjustment mode, press the Up/Downkeysto
adjust the volume.
• Pressthekeyprogrammedas[Squelch Off] to hear
backgroundnoise.
• PressthePF-2keytoswitchbetweenVolumeAdjustment
mode and Channel Select mode.
TRANSMITTING AND RECEIVING
1 In Channel Select mode, press the Up/Downkeystoselect
your desired channel.
• Afterselectingachannel,thetransceiverannouncesthe
channelnumberandtheLEDindicatorblinksyellowfora
number of times corresponding to the channel number. For
example, when selecting channel 3, “three” is announced and
theLEDindicatorblinksyellow3times.
• PressthePF-2keytoswitchbetweenVolumeAdjustment
mode and Channel Select mode.
2 Tomakeacall,pressandholdthePTT switch,thenspeak
intothemicrophoneusingyournormalspeakingvoice.
• Holdthemicrophoneapproximately1.5inches(3to4cm)from
your mouth.
3 Release the PTT switch to receive.
Note:
◆ Whenthebatterypackvoltagebecomestoolow,transmission
will stop and an alert tone will sound. (Low Battery Warning:
While operating the transceiver, the Low Battery Warning
sounds an alert tone every 30 seconds and the LED indicator
blinksredwhenthebatteryneedsrechargedorreplaced.)