Instruction Manual

safety
●
Always use the filter and never
overfill - boiling water may splash
out.
●
Avoid contact with steam coming
out of the spout area when pouring
and out of the lid when refilling.
●
Beware: the metal body of the kettle
will get hot during operation.
●
Keep small children away from the
kettle and never let the cord hang
down over the worktop edge - a
child could grab it and pull the kettle
down.
●
If you do not need so much cord,
shorten it by winding any excess
cord inside the powerbase .
●
Always unplug your kettle
when not in use.
●
Never put the kettle, powerbase,
cord or plug in liquid.
●
Do not use if there is any damage
to the kettle, powerbase, cord or
plug. Get it checked or repaired: see
‘service’.
●
This kettle is not intended for use by
young children or infirm persons
without supervision.
●
Young children should be supervised
to ensure they do not play with the
appliance.
●
Caution: Do not operate the kettle
on an inclined surface.
●
Only use the powerbase supplied
and keep it clean and dry.
●
Make sure the lid is secure before
switching the kettle on.
●
Warning: Do not remove the lid
while the water is boiling.
●
Make sure the kettle is switched off
before lifting or pouring.
●
Remove the kettle from the base
before filling or pouring.
●
Never put the kettle near or on
cooker hot plates or gas burners.
●
This kettle is for boiling water only.
●
This kettle is for domestic use only.
●
Failure to observe these cautions
may result in damage to the kettle.
before plugging in
●
Make sure your electricity supply is
the same as the one shown on the
underside of your kettle.
●
This kettle complies with European
Economic Community Directive
89/336/EEC.
before using for the first time
●
Remove all packaging and any
labels.
●
Adjust the length of the cord - pull
the cord out of the base to lengthen.
To shorten the cord turn the handle
on the underside of the powerbase
clockwise.
●
Fill to ‘MAX’, boil, then pour the
water away. Repeat 2 to 3 times.
know your Kenwood jug
kettle
 lid
 scale filter
 water level gauges
 on/off switch with neon
 360˚ powerbase
 cord winder handle
to use your jug kettle
1 Fill the kettle through the lid. The
water level must be between 'Max'
and 200ml (1 cup).
●
Always use the filter and never
overfill - boiling water may splash
out.
●
Be economical: do not boil more
water than you need.
●
To improve the quality of your drinks
always use fresh water.
●
Empty the kettle after each use.
2 Check the lid is closed.
3 Plug in and switch on. The neon will
come on.
4 Your kettle will boil and switch off
automatically. To re-boil, wait a few
seconds - the on/off switch needs
time to reset.
2
English