Operation Manual

4 Press and release the PTT switch, then rotate the Channel

selector to your desired channel.

• Upon pressing and releasing the PTT switch, a beep will sound

and the transceiver announces “Tone one”.

5 Press the Side 1 or Side 2 key to increment/ decrement the

Tone number, to select the new tone or code.

• QT/DQT table numbers and their corresponding tones/ codes

are provided in the table on page 15.

• Press and hold the

Side 1 or Side 2 key to increment/

decrement the Tone number by 5 at a time.

• A voice announcement will inform you of the currently selected

Tone number.

6 Press the PTT switch within 5 seconds to save the setting,

otherwise the operation will cancel.

• A beep will sound.

• Repeat steps 4 to 6 to set up another channel.

7 Turn the transceiver power OFF and then ON again to

activate the new settings.

Note: The transceiver will automatically return to normal operation

if no action is performed for 5 seconds.