Operation Manual

3
Indicator
• Makesurethemetalcontactsof
the battery pack mate securely
with the charger terminals.
• Theindicatorlightsredand
charging begins.
4 When charging is completed, the indicator lights green.
Removethebatterypackorthetransceiverfromthe
charging slot of the charger.
• Ittakesapproximately3hourstochargethebatterypack.
• Whenthechargerwillnotbeusedforalongtime,unplugthe
ACadapterfromtheACoutlet.
Note:
◆ When an abnormality occurs during charging, the indicator performs
as follows:
Blinks Red: Thebatterypackiseitherdefectiveorthebatterypack
contacts are not properly mated with those of the charger.
Alternates Flashing Green and Orange: Thebatterypackhasnot
satisedthechargingstarttemperature.Removethebatterypack
from the charger and wait until it reaches a normal temperature before
charging it again.
◆ Theambienttemperatureshouldbebetween5°Cand40°Cwhile
charging is in progress. Charging outside this range may not fully
charge the battery.
CHARGING THE BATTERY PACK
Thebatterypackisnotchargedatthefactory;chargeitbefore
use.
ATTENTION:
◆ AlwaysswitchOFFatransceiverequippedwithabatterypack
before inserting the transceiver into the charger.
1 PlugtheACadaptercableintothejacklocatedontherear
of the charger.
2 PlugtheACadapterintoanACoutlet.
3 Slideabatterypackoratransceiverequippedwitha
battery pack into the charging slot of the charger.