Operation Manual

4
INSTALLING THE BELT CLIP
Do not use glue which is designed to prevent screw loosening when
installingthebeltclip,asitmaycausedamagetothetransceiver.Acrylic
ester, which is contained in these glues, may crack the transceiver’s back
panel.
Beltclip
If necessary, attach the belt clip using
thetwosuppliedM3x8mmscrews.
Note:
◆ If the belt clip is not installed, its
mounting location may get hot during
continuous transmission or when left
sitting in a hot environment.
◆ Thebatterypacklifeisoverwhenitsoperatingtimedecreaseseven
thoughitisfullyandcorrectlycharged.Replacethebatterypack.
◆ WhileoperatingthetransceiverusingaLi-ionbatterypackinareasof
anambienttemperatureof–10°Candlower,operatingtimemaybe
shortened.
BATTERY LIFE
Theoperatingtimeslistedinthetablebelowaremeasured
under the following cyclic conditions:
Calculatedusing5%transmittime,5%receivetime,and90%
standby time.
Battery Type
Operating Time/ Hours (Approx.)
Digital Mode Analog Mode
Battery Saver
On
Battery Saver
Off
Battery Saver
On
Battery Saver
Off
KNB-45L
Supplied battery
16 H 14H 18H 14H
KNB-69L
Optional battery
22 H 18H 24H 18H