Operation Manual

5
INSTALLING THE CAP OVER THE SPEAKER/
MICROPHONE JACKS
Installthecapoverthespeaker/microphonejackswhennot
usinganoptionalspeaker/microphoneorheadset.
Note:
◆ Tokeepthetransceiverwaterresistant,youmustcoverthe
speaker/microphonejackswiththesuppliedcap.
1 Placethecapoverthejackssothatthelocking
tabs insert into the transceiver grooves.
2 While holding the cap in place, push it towards
the bottom of the transceiver until the tabs on
the cap click into place.
• Toremovethecap,holdthetopofthecapin
placewithyourngerwhileinsertinga2mmor
smaller flat blade screwdriver under the bottom
ofthecap.Slowlyslidethescrewdriverinuntilits
tip touches the tab inside the cap, then gently pry
thecapup(handleofscrewdrivermovingaway
fromthetransceiver)toremovethecap.