Manual

CHARGING THE BATTERY PACK

ATTENTION:

◆ Always switch OFF a transceiver equipped with a battery pack before inserting the

transceiver into the charger.

1 Plug the AC adapter cable into the jack located on the rear of the charger.

2 Plug the AC adapter into an AC outlet.

3 Slide a battery pack or a transceiver equipped with a battery pack into the

charging slot of the charger.

• Make sure the metal contacts of the battery pack mate securely with the

charger terminals.

• The indicator lights red and charging begins.

Indicator

4 When charging is completed, the indicator flashing green. Remove the battery

pack or the transceiver from the charging slot of the charger.

• It takes approximately 3 hours to charge the battery pack.

• When the charger will not be used for a long time, unplug the AC adapter

from the AC outlet.

Note:

◆ When the indicator blinks red, the battery pack is either defective or the battery pack

contacts are not properly mated with those of the charger.

◆ When the indicator ashes green and orange, the battery pack has not satised the

charging start temperature. Remove the battery pack from the charger and wait until it

reaches a normal temperature before charging it again.

◆ The ambient temperature should be between 5°C and 40°C while charging is in

progress. Charging outside this range may not fully charge the battery.

◆ The battery pack life is over when its operating time decreases even though it is fully

and correctly charged. Replace the battery pack.