Manual

EMERGENCY OPERATION

If your transceiver has been programmed with the Emergency function, you can

make emergency calls.

1 Press and hold the key programmed as Emergency.

• Depending on the delay time programmed into your transceiver, the length of time

you must hold the Emergency key will vary.

• When the transceiver enters Emergency mode, the transceiver will change to the

Emergency channel and begin transmitting based on how the transceiver is set up

by your dealer. Transmit periods are also set by your dealer.

2 To exit Emergency mode, press and hold the Emergency key again.

• If the Emergency mode completes the preset number of cycles, Emergency mode

will automatically end and the transceiver will return to the channel that was in use

before Emergency mode was entered.

Note: Your dealer can set the transceiver to emit tones and received signals as normal or mute the

speaker during Emergency operation.

LONE WORKER MODE

Lone Worker Mode is a safety feature built into the transceiver. If the transceiver

is not operated for a period of time that exceeds the programmed time, the

transceiver will emit a tone and automatically enter Emergency operation.

The default Lone Worker duration is 10 minutes. Your dealer can set the

duration to last from 1 minute to 60 minutes.

The Lone Worker function can be toggled ON or OFF by pressing and holding

the key programmed as Lone Worker for 2 seconds.