Owner's manual

BASIC OPERATIONS

Switching power on/ oFF

Press to switch the transceiver ON.

• A beep sounds and the display illuminates.

• If the Transceiver Password function is programmed, “PS” will appear on the display

when the power is turned ON. Refer to “Transceiver Password”, below.

Press again to switch the transceiver OFF.

n Transceiver Password

To enter the password:

1 Press / to select a digit.

• When using a keypad, simply enter the password digits and proceed to step 3.

2 Press C> to accept the entered digit and move to the next digit.

• Press A or # to delete an incorrect digit. Press and hold A or # to delete all

digits.

• Repeat steps 1 and 2 to enter the entire password.

3 Press S or to conrm the password.

• If you enter an incorrect password, the transceiver remains locked.

AdjuSting the Volume

Press the Volume Up key to increase the volume. Press the Volume Down key

to decrease the volume.

If Squelch Off has been programmed onto a key, you can use that function to

listen to background noise while adjusting the volume level.

Selecting A Zone And chAnnel

Select the desired zone and channel using the keys programmed as Zone Up/

Zone Down and Channel Up/ Channel Down.

• “G1” (Zone 1) appears on the display.

trAnSmitting/ receiVing

1 Select your desired zone and channel.

• In Voting and Voting with Signaling zones, the channel is selected automatically.

2 Press microphone PTT switch and speak into the microphone to transmit.

Release the PTT switch to receive.

• For best sound quality at the receiving station, hold the microphone approximately

1.5 inches (3 ~ 4 cm) from your mouth.