Owner's manual

ii
CONTENTS
GETTING STARTED ................................................................................................1
GETTING ACQUAINTED .........................................................................................
3
PROGRAMMABLE FUNCTIONS .............................................................................
4
BASIC OPERATIONS ...............................................................................................
5
SCAN ........................................................................................................................
6
DTMF CALLS ...........................................................................................................
7
SIGNALING ..............................................................................................................
8
FleetSync: ALPHANUMERIC 2-WAY PAGING FUNCTION .....................................9
5-TONE SIGNALING ..............................................................................................
10
ADVANCED OPERATIONS ....................................................................................
10
BACKGROUND OPERATIONS ..............................................................................
13
PrecauTions
Observethefollowingprecautionstopreventre,personalinjury,andtransceiver
damage.
• Donotattempttocongurethetransceiverwhiledriving;itistoodangerous.
• Do not disassemble or modify the transceiver for any reason.
• Do not expose the transceiver to long periods of direct sunlight, nor place it near heating
appliances.
• If an abnormal odor or smoke is detected coming from the transceiver, switch the
transceiver power off immediately, and contact your
Kenwood dealer.
• Useofthetransceiverwhileyouaredrivingmaybeagainsttrafclaws.Pleasecheck
and observe the vehicle regulations in your area.
• Donotuseoptionsnotspeciedby
Kenwood.
◆ The transceiver operates in 12 V negative ground systems only! Check the battery polarity and
voltage of the vehicle before installing the transceiver.
◆ Use only the supplied DC power cable or a Kenwood optional DC power cable.
◆ Donotcutand/orremovethefuseholderontheDCpowercable.
For passenger safety, install the transceiver securely using the supplied mounting bracket and
screw set so the transceiver will not break loose in the event of a collision.