Owner's Manual

ManualsBrandsKenwood ManualsCar Audio & VideoExcelon

X502-1

XM502-1

CLASS D MONO POWER AMPLIFIER

INSTRUCTION MANUAL

AMPLIFICATEUR MONO CLASSE D

MODE D’EMPLOI

AMPLIFICADOR DE POTENCIA CLASE D MONOFÓNICO

MANUAL DE INSTRUCCIONES

Take the time to read through this instruction manual.

Familiarity with installation and operation procedures will help you obtain the best performance from

your new power amplier.

For your records

Record the serial number, found on the back of the unit, in the spaces designated on the warranty card, and in the

space provided below. Refer to the model and serial numbers whenever you call upon your Kenwood dealer for

information or service on the product.

Model X502-1 /XM502-1 Serial number

US Residence Only

ww.kenwood.com/usa

213 mm (8-3/8)

149 mm (5-7/8)

53 mm

(2-1/16)

Accessories / Accessoires / Accesorios

①

Ø4×16 mm

Self-tapping screws

Vis taraudeuses

Tornillo autorroscantes

②

Speaker level input cable

Câble d’entrée de niveau d’enceinte

Cable de entrada del nivel de altavoces

Dimensions / Dimensions / Dimensiones

KENWOOD

JVCKENWOOD Corporation

■

I I

■

""-

KBIIWOOO

'\..@

Summary of content (10 pages)

PAGE 1
KENWOOD X502-1 XM502-1 CLASS D MONO POWER AMPLIFIER INSTRUCTION MANUAL AMPLIFICATEUR MONO CLASSE D MODE D’EMPLOI AMPLIFICADOR DE POTENCIA CLASE D MONOFÓNICO MANUAL DE INSTRUCCIONES JVCKENWOOD Corporation ■ Accessories / Accessoires / Accesorios ① Speaker level input cable Câble d’entrée de niveau d’enceinte Cable de entrada del nivel de altavoces 4 ② 1 I I 213 mm (8-3/8̯) Dimensions / Dimensions / Dimensiones 149 mm (5-7/8̯) ■ Self-tapping screws Vis taraudeuses Ø4×16 mm Tornillo autorroscantes
PAGE 2
Safety precautions WARNING To prevent injury or fire, take the following precautions: • Mounting and wiring this product requires skills and experience. For safety’s sake, leave the mounting and wiring work to professionals. • When extending the ignition, battery, or ground wires, make sure to use automotive-grade wires or other wires with the range of 5 mm2 (AWG 10) or more to prevent wire deterioration and damage to the wire coating.
PAGE 3
Installation / Installation / Instalación ① Parts included Pièces comprises Partes incluidas Dressing cover Enjoliveur Cubierta de adorno Installation board, etc. (thickness: 15 mm or more) Tableau d’installation, etc. (épaisseur: 15 mm ou plus) Tablero de instalación, etc.
PAGE 4
Connections / Raccordements / Conexiones WARNING Remove the ignition key and disconnect the negative ⊖ terminal of the battery to prevent short circuits. AVERTISSEMENT Retirer la clé de contact et débrancher la borne négative ⊖ de la batterie pour éviter les court-circuits. ADVERTENCIA Retire la llave de encendido y desconecte el terminal negativo ⊖ de la batería para evitar cortocircuitos.
PAGE 5
Connections / Raccordements / Conexiones ■ ■ ■ RCA INPUT connection Raccordement RCA INPUT Conexión RCA INPUT AFTER MARKET HEAD UNIT FRONT L L R R RCA cable Câble RCA Cable RCA ■ ■ ■ Speaker level input connections Raccordement au niveau haut-parleur Conexión para entrada de altavoz R L Power control wire Câble de commande de l’alimentation Cable de control de alimentación FACTORY INSTALLED HEAD UNIT NOTE Do not connect cables and leads to both RCA cable input jacks and the speaker level inpu
PAGE 6
Controls I Contra/es I Controles ® GND SPEAKER OUTPUT P.CON o e (J) [7!~ ~ ~~E IN ~ SPLEVELIN"1T® ~ REMOTE 1 2 4 3 (!I @ 8 13 10 @ @ INFRASONIC F ILTER OFF ......., ON ,--, ~ 5 150 ,1 -~□;5 1-~~2 ::~180 0.2 [MAX) INPUT SENSITIVITY IV) 0 18 50 BASS BOOST LEVEL [dB) KENWOOD 200 LPF FREGUENCY[Hz] @ 9 12 11 CD Fuse (30 Ax 2) ® INPUT SENSITIVITY control INOTE I Set this control according to the pre-output level of the HEAD UNIT connected with this unit.
PAGE 7
Troubleshooting Guide What might appear to be a malfunction in your unit may just be the result of slight misoperation or miswiring. Before calling service, first check the following table for possible problems. POSSIBLE CAUSE SOLUTION IPROBLEM I No sound. • Input (or output) cables are disconnected. • Connect the input (or output) cables. (No sound from one • Protection circuit may be activated. • Check connections by referring to “Protection side.) function”. (Blown fuse.) • Volume is too high.
PAGE 8
Specifications Specifications subject to change without notice. Audio section Rated power output (+B = 14.4 V) (4 Ω) (20 Hz–200 Hz, ≤ 1.0% THD) ...............................300 W × 1 (2 Ω) (100 Hz, ≤ 1.0% THD)...............................................500 W × 1 Speaker impedance.............................4 Ω (2 Ω to 8 Ω allowable) Frequency response (+0, −3 dB)............................. 20 Hz–200 Hz Input sensitivity (RCA)............................................................0.2 V–5.
PAGE 9
For Europe / Pour l’Europe / Para Europa CE X502-1 only / X502-1 uniquement / X502-1 solamente Declaration of Conformity with regard to the EMC Directive 2014/30/EU Declaration of Conformity with regard to the RoHS Directive 2011/65/EU Manufacturer: JVCKENWOOD Corporation 3-12, Moriya-cho, Kanagawa-ku, Yokohama-shi, Kanagawa, 221-0022, JAPAN EU Representative: JVCKENWOOD Europe B.V.
PAGE 10
For U.S.A. FCC CAUTION Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant Supplier’s Declaration of Conformity to part 15 of the FCC Rules.