Owner's Manual
Table Of Contents
IA CAUTION I
• If sound
is
not
output
normally, immediately
turn
power
off
and check connections.
Be
sure
to
turn the
power
off
before changing the
setting
of
any switch.
If
the
fusc blows, check wires for shorts, then
replace
the
fuse
with
one
of
the same rating.
• Check that
no
unconnected
wires or connectors
are
touching
the
car body. Do
not
remove caps
from
unconnected
wires or connectors to prevent
short circuits.
• Connect
the
speaker wires to
appmpriate
speaker
connectors separately. Sharing the negative wire
of
the speaker or
grounding
speaker wires
to
the
metal
body
of
the car can cause this
unit
to
fail.
• After installation, check
that
the
brake lamps,
winkers, and wipers work properly.
2.Strip
the
wire
Make a cut in the wire sheath (insulator made from vinyl, etc.)
at the position
10
13
mm
(3/8"
···1/2") away from the end
of
the
wire, and then remove the unnecessary portion
ofthe
sheath
by twisting
it.
3. Install
the
wire
Loosen the screw using the supplied hexagon wrench. Insert
the conductor
of
the wire
in
the terminal hole, and then
tighten the screw.
I I
1--1
10
-
13
mm
(3/8" - 1/2")
Hexagon
Wrench
(Large)
English
7