User's Manual

B. Receiver bell:
1. Gently lift the unit from the packaging. ( Fig I)
2. To install batteries: Turn the top cap with hook in a clockwise direction and remove the cap and outer bell housing.
Install 4 “AA “sized batteries (not included) in the battery compartment.
3. Replace the bell and turn the top cap anti-clockwise to lock.
Place the receiver bell on a table with the stand or place on a Christmas tree using the hanging hook. (See Fig.I)
4. Turn the "HI /LO/Off " switch to "HI" or “LO” depending on the desired music level. The music will play and the
LED will flash until the song is over.
5. The receiver bell plays in the same mode as the main unit. If the main unit is in the presence activation mode, the
receiver bell will also be in the presence activation mode and play once and stop.
6. The main unit and receiver bell may play different songs at the same time.
Stand Fig.VI
III. TROUBLESHOOTING
Problem
No music or no light
flashing
Likely Cause
No power
Volume control switch
is at the minimum position
Motion sensor is not
activated
Solution
Make sure the 4 AA sized batteries are inserted
correctly to the control box and receiver bell
separately.
Turn on the volume control switch to adjust the
volume of the music.
Turn the "Continuous/Off/Presence Activated" switch
to
Presence Activated and approach the front of the unit.
Receiver bell not HI/LO/OFF switch on OFF Turn to ON.
playing music Receiver bell’s song has New song will start when main unit’s song is
finish but main unit’s song over and a new song starts.
is still playing