User's Manual
STEP #2
Check the Electrical Supply Requirements
This product must be installed in accordance with national, state and local electric codes. The following
table provides the correct voltage, amperage and frequency that must be supplied to the cooktop.
The supply must be from an individual grounded circuit that is protected by a circuit breaker and rated
per the specications for the various models as shown in the table below.
STEP #3
Countertop Preparation
Please read this section prior to making cutout for cooktop.
It is important to plan ahead for installation of the cooktop, keeping the following dimensions in mind
(please refer to Figure A).
A - 13 inches maximum depth of overhead cabinets
B - 36 inches is minimum height of countertop above oor
C - The minimum at countertop surface that the cooktop will rest upon
must be equal to or greater than the overall cooktop dimensions (refer to the
following page for overall cooktop dimensions).
D - 30 inches minimum clearance between the top of the cooking surface
and the bottom of an unprotected wood or metal cabinet or 24 inch minimum
clearance when the bottom of wood or metal cabinet is protected by not less
than 1/4-inch thick ame retardant millboard covered with not less than No. 28
MSG sheet steel, 0.015-inch thick stainless steel, 0.024-inch thick aluminum or
.020-inch thick copper.
E -1 inch minimum from backsplash of coutner top to edge of glass (refer to
the following page for overall cooktop dimensions). 1-1/2 inch minimum from
front of counter to glass.
For installations in Canda: “Do not install closer than 1/2-inch
(12mm) from any adjacent surface”. Ne pas installer a’mdins de 12mm
detoute surface adjacente.
Fig. A
3
KENYON Max Connected Power Supply Minimum Wire Size
Part # Load Input
B40575 2400 Watts 120V AC 20A 60Hz #12 AWG
B40572 1200 Watts 120V AC 10A 60Hz #12 AWG
B41573 1200 Watts 120V AC 10A 60Hz N/A, Unit equipped w/ GFCI cord
B41570 1200 Watts 120V AC 10A 60Hz N/A, Unit equipped w/ GFCI cord
B40576 2400 Watts 240V AC 10A 60 Hz #12 AWG
B40571 1200 Watts 240V AC 5A 60Hz #12 AWG
B40547 4200 Watts 240V AC 17.5A 60Hz #12 AWG
!
WARNING
If the electrical supply does not meet the product
*Note steps 3 thru 5 do not apply to model B41570