Owner's Manual

A - 13 inches maximum depth of overhead cabinets

B - 36 inches is minimum height of countertop above oor

C - The minimum at countertop surface that the cooktop will rest

upon must be equal to or greater than the overall cooktop

dimensions (refer to the following page for overall cooktop

dimensions).

D - 30 inches minimum clearance between the top of the cooking

surface and the bottom of an unprotected wood or metal cabinet or

24 inch minimum clearance when the bottom of the wood or metal

cabinet is protected by not less than 1/4-inch-thick ame retardant

millboard covered with not less than No. 28 MSG sheet steel,

0.015-inch-think stainless steel, 0.024-inch-thick aluminum or

0.020-inch-thick-copper.

E - 1-inch minimum from backsplash of countertop to edge of glass

(refer to the following page for overall cooktop dimensions).

FOR INSTALLATIONS IN CANADA: “Do Not Install Closer Than 1/2 Inch

(12mm) From Any Adjacent Surface”, and NE PAS INSTALLER A’MDINS DE 12MM

DETOUTE SURFACE ADJACENTE.

Warning: To eliminate the risk of burns by reaching over heated

surface units, cabinet storage space located above surface units

should be avoided. If cabinet storage is to be provided, the risk can

be reduced by installing a range hood that projects horizontally a

minimum of 5” beyond the bottom of the cabinets.

Before making the countertop cutout, check for clearance. Check to see if the cooktop will clear

the front and side walls of the base cabinet. It is also important to provide enough ventilation.

Adequate ventilation of the space below the

countertop must be provided to ensure

proper operation of the cooktop. Heat

transferred from the cooktop bottom pan

during operation will overheat an improperly

ventilated area.

Allow a 2” minimum clearance between the bottom of the metal pan of the cooktop and any

combustible surface located below, ie: the upper edge of a drawer installed below the cooktop

(see Fig. B). Failure to provide proper clearance and ventilation may result in a re hazard.

Fig. A

2 INCH (51mm) MINIMUM

Fig. B