www.CookWithKenyon.
Contents IMPORTANT SAFETY INSTRUCTIONS 3 Product Specifications 5 Before Using the Grill Quick Start Tips Stuffed French Toast 6 7 Operation Touch Control Calibration Turning on the Grill Heat Settings Turning Off the Grill Automatic Shut-Off Preheat and Auto Shut-Off Time Temperature Guide Power Cord Grill Parts Lid Lid Removal 9 9 9 9 10 10 10 10 11 12 13 13 Installation Unpacking the Grill Check Electrical Supply Requirements Countertop Preparation Drain Connection Outlet Location Final Preparati
IMPORTANT SAFETY INSTRUCTIONS Read this section BEFORE operating the grill. The following information applies to all KENYON Grills. THIS GRILL, LIKE ALL APPLIANCES, HAS THE POTENTIAL TO CREATE SAFETY PROBLEMS THROUGH CARELESS AND IMPROPER USE. PLEASE OBSERVE ALL OF THE FOLLOWING SAFETY PRECAUTIONS. Read ALL instructions prior to using product. Do not let cord hang over edge of table or counter, or touch hot surfaces. CAUTION Do not touch hot surfaces. Use handles or knobs.
IMPORTANT SAFETY INSTRUCTIONS Do not replace or attempt to repair any part of the grill, unless otherwise noted in this manual. All other service is to be performed by a factory authorized technician. Do not store flammable materials near the grill. Do not wear loose fitting or hanging apparel when using the grill. Ensure grill is installed per instructions and properly grounded by a qualified electrician.
Product Specifications SilKEN® Grill Built-in Models BURNER DATA - Model B70070 (120V) - Model B70071 (240V) VOLTAGE 120V AC 240V AC AMPS 11 6 OUTPUT IN WATTS 1300 1300 PRODUCT DIMENSIONS 8 ½" 4" 21" 12" WIDTH 21” DEPTH 12” 533.4mm 304.8mm 19 ¾" 11 ⅝" CUTOUT DIMENSIONS WIDTH 19 3/4” 501.6mm Portable Models - Model B70072 (120V) - Model B70073 (240V) 16 ⅛" HEIGHT 5” (9 1/2” with lid) 127mm (241.3mm with lid) DEPTH 11 5/8” 295.2mm RADIUS 1/4” 6.
Before Using the Grill 6 1 Remove the cooking grate and drip tray from the grill. Wash the grate with warm soapy water using a non-abrasive cloth. USE ONLY HIGH TEMP PLASTIC UTENSILS WHEN GRILLING. Visit our web site to purchase a set of high quality stainless steel/high temp plastic grill utensils, www.cookwithkenyon.com. Preheat grill for 5 to 9 minutes on high (8 bars illuminated). Adjust heat setting for type of food.
Before Using the Grill 15 13 Wipe the stainless steel surfaces with a damp cloth to remove any residue from previous grilling sessions. The touch control area is ceramic glass which is sealed from the effects of rain, snow and ice. To clean the glass, use a glass cleaner and soft towel. If stains appear, use a ceramic glass cleaner which can be found in your local grocery store. 14 Your Kenyon grill came with a sample bottle of stainless steel cleaner.
Operation DO NOT USE WATER ON GREASE FIRES Smother fire or flame or use dry chemical or foam-type extinguisher. CLEAN GRILL AFTER EACH USE This appliance is equipped with removable, disposable drip trays. The drip trays MUST be removed and cleaned after each and EVERY use. Do not allow grease to accumulate between cooking. The drip trays and baffle tray MUST be used when cooking on the grill. Excessive grease may spill over into the interior of the grill, voiding your warranty and posing a fire hazard.
Operation Calibration Touch Control POWER LEVEL DISPLAY Upon application of electrical power to the grill, the controller will run a self-calibration process. The controller will then sound an audible confirmation tone and the display will briefly illuminate. The grill is now ready to be used. (+) POWER SENSOR POWER ON INDICATOR POWER LEVEL GRAPHIC MASTER POWER SENSOR (-) POWER SENSOR Turning On the Grill Power On Indicator This display indicates whether the grill is ON or OFF.
Operation Preheat and Automatic Shut-Off Time The heating element cycles at different time intervals to vary the heat level. As the setting is increased, the heating element will remain on for a longer period, increasing the cooking temperature of the grill. The grill will preheat at full power for the specified time and heat settings listed in the table below. In the number 8 setting there is no preheat as the grill is at full power all ready.
Operation Power Cord GROUNDED 3-PRONG PLUG THIS PERTAINS TO 120V MODELS ONLY Ground Fault Circuit Interrupter (GFCI) The GFCI is a safety device designed to protect the user from any electrical shock hazard. Indicator Light The indicator light will stay illuminated when electrical power is applied and indicates that the GFCI is working properly. Test/Emergency Off Button Pressing this button will test the GFCI. The indicator light will go out and electrical power will not be supplied to the grill.
Operation Grill Parts GRATE Heating Element The heating element is designed to pivot as shown to remove/replace the baffle tray and drip tray. It will stay in the up position. To put down apply slight downward pressure. Baffle Tray The baffle tray supports the drip tray, heating element and grate and must always be used when operating the grill. DRIP TRAY Drip Tray The disposable drip tray collects all the fat and juices created during the cooking process. The drip tray must be emptied after each use.
Operation Lid The SilKEN® Grill incorporates a high temperature silicone lid. Through the use of silicone, the lid can collapse accordion-style to a height of two inches. The insulation quality of high temperature silicone allows for very fast and even heat while the lid helps to prevent accidental burns. With the quick release pin removed, grasp the lid, lifting on the left side to clear the hinge and slide it to the left until clear of the hinge pin on the right.
Installation Unpacking the Grill PARTS INCLUDED 1 Carefully unpack the grill from its shipping container. If possible, retain the original shipping carton and protective packaging in the event the unit ever has to be returned for service. Verify and identify the package contents. The following items should be included in the carton. If any components are missing or damaged, call KENYON immediately.
Installation Countertop Preparation D - 30 inches minimum clearance between the top of the cooking surface and the bottom of an unprotected wood or metal cabinet or 24 inch minimum clearance when the bottom of the wood or metal cabinet is protected by not less than 1/4-inch-thick flame retardant millboard covered with not less than No. 28 MSG sheet steel, 0.015-inch-think stainless steel, 0.024-inch-thick aluminum or 0.020-inch-thickcopper.
Installation If your countertop is made of stone you will need to use an acrylic latex to mount the grill in place. Put a large bead of caulk around the cutout opening and place the grill in place. Wipe away any excess caulk, use water to remove the excess caulk. Allow the caulk to dry for a minimum of 24 hours without any moisture being allowed to come in contact with the caulk. Do not use the screws that came with your grill. The caulk will hold the grill securely.
Installation Final Preparations Prior to Use Outlet Location 5 Be sure the electrical outlet intended for the grill is in an easily accessible location. This allows the user to easily plug and unplug the grill. This is necessary to ensure safe cleaning and storage of the grill. 6 Remove the protective plastic film from the lid, trim flange and glass panel. Clean the grill before you use it for the first time.
Warranty Kenyon International, Inc (the “Company”) warrants its products in normal usage to be free of defects in materials and workmanship subject to the conditions and limitations below. Any part, which proves to be defective in normal usage during the warranty period will be repaired or replaced by the Company. This warranty covers certain products built by the Company and is subject to the following conditions and limitations: 1.