Use and Care
10
KENYON Max Load Power Supply Plug Type
Part #
B70050
B70080
B70082 1300 Watts 120V AC 11A 60Hz 3 prong grounded
B70085 cord with GFCI
B70090
B70051
B70081 1300 Watts 240V AC 6A 60Hz 3 wire SO cord no plug
B70086
Electrical Requirements
Check the Electrical Supply Requirements
This product must be installed in accordance with national, state and local electric codes. The
following table provides the correct voltage, amperage and frequency that must be supplied to the
grill.
The supply must be from an individual grounded circuit that is protected by a circuit breaker and
rated per the specications for the model as shown in the table below.
WARNING:
If the electrical supply does not meet the product specications, consult with a
licensed electrician before proceeding with installation!
Do not remove the GFCI device from the supplied power cord under any circumstances.
Your All Seasons™ Grill is supplied with a factory installed polished stainless steel ange that
accepts four oval head wood screws for mounting. The trim ange of the grill is designed to hold
the unit rmly in place in the countertop. If desired, you may seal the edge of the countertop
beneath the trim ange. We recommend a NON-ADHESIVE such as acrylic latex caulk. This will
help reduce the chance of damage to the trim ange should the unit need to be removed from
the countertop. Should you need to remove the unit from the countertop after installation simply
take a piece of shing line and run back and forth under the trim ange to break the caulk bond.
WARNING:
Allow a 2 inch (2”) minimum clearance between the bottom of the grill and combustible
surface located below, ie: the upper edge of a drawer installed below the grill (Fig. 3, page
12). Failure to provide proper clearances and ventilation may result in a re hazard.
Countertop Installation