Owner manual

Doors.NET Reference Manual
- 386 -
13. Finally, open a cardholder record (Home > Cardholders). Select a cardholder
record and enter a PIN number in the field, as shown.
14. Now that the feature is setup you can present a valid card to the keypad and
access will not be granted unless it is followed with the cardholder's associated
PIN.
15. To set the keypad back to card-only mode it will need to be set to 'lock' - Or remove
the Dual Verification Timezone by setting it to Never or None.
16. Individual cardholders can also be set to 'PIN Exempt' - this means they will not
need to enter a PIN number if the door is in Card and PIN mode.
17. Click on the Advanced tab of a cardholder record, then go to the Advanced tab and
place a check mark against 'PIN Exempt'.