Manual

ManualsBrandsKeri Systems ManualsSensorsKE-8

KE-8 Controller Enclosure

Installation Guide

Page 1 of 5 P/N: 01515-001 Rev. C

Section 1 – Specifications

Section 2 – Wall Mounting the Enclosure

Section 3 – Controller Installation

Section 4 – Tamper Relay Board Mounting

Section 5 – Wire Routing

Section 6 – Keri Contact Information

The KE-8 Controller Enclosure handles up to four NXT Controllers or PXL Controllers in a powder-coated, steel box. 

The KE-8 has two locks to ensure the lid is secured to the enclosure body.

1.0 Specifications

1.1 Dimensions

• 15.75 inches tall by 17.50 inches wide by 6.625 inches deep

• 40.00 cm by 44.45 cm by 16.83 cm

1.2 Weight

• 13.6 lbs / 6.17 kgs – Enclosure only

• Up to 25 lbs (11 kgs) for a fully loaded enclosure

1.3 Knockouts

• 14 at 0.688 inches (1.75 cm) – 4 each top and bottom, 3 each left and right sides

• 4 at 0.880 inches (2.24 cm) – 2 each top and bottom

Summary of content (5 pages)

PAGE 1
KE-8 Controller Enclosure Installation Guide Section 1 – Specifications Section 2 – Wall Mounting the Enclosure Section 3 – Controller Installation Section 4 – Tamper Relay Board Mounting Section 5 – Wire Routing Section 6 – Keri Contact Information The KE-8 Controller Enclosure handles up to four NXT Controllers or PXL Controllers in a powder-coated, steel box.  The KE-8 has two locks to ensure the lid is secured to the enclosure body. 1.0 Specifications 1.1 Dimensions • • 1.2 • • 1.3 • • 15.
PAGE 2
KE-8 Controller Enclosure Installation Guide 2.0 Mounting the Enclosure The enclosure has three key-hole slots and three corresponding screw holes for mounting the enclosure securely to a solid wall surface. Please ensure the mounting surface can handle the weight of the enclosure; a fully loaded enclosure  (4 controllers with peripheral boards and wiring) can weigh 25 pounds (11 kgs) or more. Refer to Figure 1 for the mounting hole pattern.
PAGE 3
KE-8 Controller Enclosure Installation Guide 3.0 Controller Installation Two Controllers can be installed in the body of the enclosure and two in the enclosure lid. Keep Controller wiring requirements in mind as you install Controllers into the enclosure. Refer to Figures 2 and 3 for Controller mounting locations. Enclosure Body - TOP Controller Mounting Locations Enclosure Lock Tabs Lid Hinge Figure 2 - Controller Mounting in Enclosure Body Page 3 of 5 P/N: 01515-001 Rev.
PAGE 4
KE-8 Controller Enclosure Installation Guide Enclosure Lid - TOP Controller Mounting Locations Locks Lid Hinge Figure 3 - Controller Mounting in Enclosure Lid Page 4 of 5 P/N: 01515-001 Rev.
PAGE 5
KE-8 Controller Enclosure Installation Guide 4.0 Tamper Annunciation Relay Board Mounting A Tamper Annunciation Relay Board is required to meet UL-294 requirements. Please refer to the Tamper Annunciation installation document for wiring instructions. Enclosure Body - TOP EDGE Tamper Annunciation Board Mounting Location Figure 4 - Tamper Relay Board Mounting 5.0 Wire Routing Eighteen knockouts are included for your convenience around the perimeter of the enclosure.