NXT Reader Installation and Setup Guide NXT M Series Readers are 18.
NXT Reader Wiring to the Controller Hepatic vita Updated rate NOTE: The recommended cable type is shielded, stranded, 4-conductor, (Bellmen 8534, or equivalent) or shielded CATS.
NXT Reader Setup 1. Go to Setup =» Hardware Setting >> All this Will take you'to the hardware tees. 2; Double-click the controller which will be listed beneath the communications gateway. 3 Locate and select the: NXT reader by expanding the controller bus. 4. Once selected, the reader properties will ba displayed on the right. 5. Verify the correct NXT reader model is special for the Manufacturer Model.
. The firmware upgrade window will appear and the NXT controller will be highlighted, 5 Clicktheexpander {plus sign} located fo the left.of the controller, and you will see listed the NXT readers which are connects to the controller. ii . Tonne RRR 8. Highlight the fist: NXT reader vibe lst 7. From the Select Firmware File list, select the new firmware: 8. Ono selected, click the APPLY button. 9. You wil seed message notifying you that during the upgrade the reader may go offline fora few minutes 10.
12. Select the v 04.00.03 firmware file, then click Open. 13. The following message will appear. 14. Click Yes and the reader firmware will be updated. During the firmware upgrade the readers LED will Bash! green, red, amber, green, amber, red, amber, ele. if you cannot see the reader's LED then fakes look at the live events grid.
Mote: The NXT Exit Reader is only supported when sed with the NXT Mercury-Towered controllers . i The Process for Adding:an NXT Exit reader is as follows: 1. Open the Micromanagement program: iy the folder where your instance of Doors. NET installed (typically in the Doorstepping folder). 2. Click the License tab and scroll through the list of license values unlit you locate “Enable NXT Exit Reader”. This tern should be sett “True.
FCC Warning a 15.19 Labeling requirements. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired aeration. b 16.21 Changes or modification warning. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
