Manualshelf

User`s guide

ManualsBrandsKerio ManualsSoftwareWeb Filter EDU, 100 user add-on
12345678910
2.3 WinRoute Installation
7
chapter 1). Suppose that the ISP has aasigned IP adddress 63.55.21.12. It is also recom-
mended to assign a DNS name (e.g. kwf.company.com) to this IP address; otherwise all VPN
clients will be required to define the server by the IP address.
Verify connectivity (i.e. by using the ping command or by opening a Web site using your
browser).
LAN Interface
The following parameters will be set at the LAN Interface:
• IP address — we will use the 192.168.1.1 IP address (refer to chapter 2.1).
• network mask — 255.255.255.0
• default gateway — no default gateway is allowed at this interface!
• DNS server — for proper functionality of authentication in the Active Directory,
the particular domain server must be set as the primary DNS server (IP adresa
192.168.1.2).
2.3 WinRoute Installation
On the host which is used as the Internet gateway (see chapter 2.1), start WinRoute’s installa-
tion. Select Full installation.
If the installation program detects the Internet Connection Sharing service, it is recommended
to strictly disable this service, otherwise collisions might occur and WinRoute may work in-
correctly. It is also recommended to disable also other system services which might cause
collisions — Universal Plug and Play Device Host and SSDP Discovery Service.
In the final stage of the installation, the WinRoute’s initial configuration wizard is started where
you set administration username and password.
Under usual circumstances, a reboot of the computer is not required after the installation is
completed (a restart may be required if the installation program rewrites shared files which
are currently in use). This will install the WinRoute low-level driver into the system kernel.
WinRoute Firewall Engine and the WinRoute Engine Monitor will be automatically launched
when the installation is complete.
2.4 Basic Traffic Policy Configuration
Run the Kerio Administration Console and connect to the localhost (the local computer) with
the user name and password defined during installation. The Network Rules Wizard will be
started automatically after the first login.