Instructions

5
6-5 Attaching the Holder for 76mm * 76mm slice
6-5-1 This part is used for the observation of the76mm *
76mm slice.
6-5-2 Open the spring clip of the rectangular stage with
flexible right handle, slide the holder into its right
position (Be sure that the rectangular groove facing up),
loose the clip gently, and finally put the Slice in place.
6-6 Connecting the Cables
6-6-1Cables and cords are vulnerable when bent or
twisted. Never subject them to excessive force.
6-6-2 Make sure that the main switch of the power
supply is set to "O"(OFF) before connecting cables.
(1) Connect the plug of the lamp housing or
illumination column to connector firmly.
(2) Connect the manual controller.
6-6-3 Be sure to supply power from a grounded, 3-conductor
power outlet using the proper cord is provided. If the
power outlet is not grounded properly, we can no longer
warrant the electrical safety performance of the
equipment.
6-6-4 If the power cord or a connection cable comes in
contact with the lamp housing or surrounding
equipment, the cord or cable may melt and result in
shock hazard. To prevent this, distribute the cords and
cables apart from the lamp housing.
6-7 Attaching the Phase Contrast Optical Slider
6-7-1 This is an optional part for the observation of
phase contrast.
6-7-2 The phase contrast slide can be removed when no
relevant observation is conducted.
6-7-3 Attach the phase contrast slider to the illumination
column so that the slider's indication surface faces
upwards and the finger hook position comes on the right.
6-7-4 The phase contrast slide should be matched with the
objectives during the observation.
6-8 Attaching the Filters
6-8-1 Select the proper filter according to your need.
6-5
6-6-1
6-6-2
6-7