Owner manual

162 AET_/PET_/ILT_NM-BA-e-1410
33.1. A set of commands
Command Command description
Z Zero balance
T Tare balance
OT Give tare value
UT Set tare
S Send stable measurement result in basic measuring unit
SI Immediately send measurement result in basic measuring unit
SIA
Immediately send measurement results from both measuring
platforms basic weighing units
SU Send stable measurement result in current measuring unit
SUI Immediately send measurement result in current measuring unit
C1 Switch on continuous transmission in basic measuring unit
C0 Switch off continuous transmission in basic measuring unit
CU1 Switch on continuous transmission in current measuring unit
CU0 Switch off continuous transmission in current measuring unit
DH Set low checkweighing threshold LO
UH Set high checkweighing threshold HI
ODH
Give value of low checkweighing threshold LO
OUH Give value of high checkweighing threshold HI
NB Give balance factory number
PC Send all implemented commands
LOGIN User log in
LOGOUT
User log out
Caution:
1. Each command must end with CR LF characters;